Wiring Diagram - Steren CAR-660 Manual De Instrucciones

WIRING DIAGRAM

Follow this diagram to install your new DVD car stereo.
White: panel light
Connect to light switch
Orange: Power antenna
Connect to Power antenna or remote control from Amplifier
Yellow: Memory +
Connect to battery
Black: Ground -
Connect to Ground terminal or a metal part of the
car chassis
Red: 12V +
Connect to ignition key switch
This unit has been designed to use 4 speakers, never use only two This unit has been designed to use 4 speakers, never use only two
speakers. speakers.
Never plug the negative end from the speakers to the ground. Never plug the negative end from the speakers to the ground.
Speakers impedances is from 4 to 8ohm Speakers impedances is from 4 to 8ohm
Make sure that the frontal panel is fi rmly attached, otherwise Make sure that the frontal panel is fi rmly attached, otherwise
Release button or other buttons may not function. Release button or other buttons may not function.
Do not touch the contacts on the frontal panel or the main body, Do not touch the contacts on the frontal panel or the main body,
may result in poor electrical contact. may result in poor electrical contact.
This unit has been designed to use 4 speakers, never use only two This unit has been designed to use 4 speakers, never use only two
speakers. speakers.
Never plug the negative end from the speakers to the ground. Never plug the negative end from the speakers to the ground.
Speakers impedances is from 4 to 8ohm Speakers impedances is from 4 to 8ohm
FUSE
Left front
FUSE
Left rear
ENGLISH-10
Wires connector
Grey
Green
Green Grey
White White
Brown Blue
Brown Blue
White White
Right front
Right rear