Descargar Imprimir esta página

Publicidad

Idiomas disponibles

Idiomas disponibles

Enlaces rápidos

Please read and follow all of the instructions & safety precautions detailed below prior to using this
product. Failure to do so may result in serious personal injury and / or property damage.
Read all the instructions before using the product.
Power bank main unit contains an internal lithium polymer battery. Upon initial use or after a
prolonged storage period, fully charge it once. The unit's full performance is achieved only after 2 or 3
completed charge and discharge cycles.
Power banks are not allowed in checked luggage on commercial airline flights. Handle with care and
dispose of in accordance to local regulations. Carry-on only.
To reduce the risk of injury, close supervision is necessary when the product is used near children.
Do not put fingers or hands into the ports of product.
Do not expose power bank to rain, snow, water or liquids.
Use of a power supply or charger not recommended or sold with power bank manufacturer may result
in a risk of fire or injury to persons.
Do not use the power bank in excess of its output rating. Overload outputs above rating may result in
a risk of fire or injury to persons.
Do not use the power bank that is damaged or modified. Damaged or modified batteries may exhibit
unpredictable behavior resulting in fire, explosion or risk of injury.
Do not disassemble the power bank. Bring unit to a qualified service person when service or repair is
required. Incorrect reassembly may result in a risk of fire or injury to persons.
Do not expose a power pack to fire or excessive temperature. Exposure to fire or temperature above
100°C may cause explosion. The temperature of 100°C is equivalent to the temperature of 212°F.
Have servicing performed by a qualified repair person using only identical replacement parts. This will
ensure that the safety of the product is maintained.
Do not charge an electronic device while the power bank unit is being charged.
Disconnect charging cable from the power bank when not in use
Wireless charging is most efficient when smartphone is placed directly over the QI certified wireless
charging dock
It is recommended to remove smartphone from cases with credit card holders as wireless charging
may demagnetize credit cards
It is recommended to remove smartphone from heavy & thick cases, or from multi-functional cases
(ex: credit card holder cases or cases with magnetic feature) when recharging your device as these
may disrupt wireless charging capability
The T1029 is a UL 2056/UL2738 Certified 10,000 mAh power bank with QI Certified wireless charging
capability. Please see below product specifications & user guide.
WARNING
T1029 USER MANUAL

Publicidad

loading

Resumen de contenidos para Spector&Co Super Titan T1029

  • Página 1 WARNING Please read and follow all of the instructions & safety precautions detailed below prior to using this product. Failure to do so may result in serious personal injury and / or property damage.  Read all the instructions before using the product. ...
  • Página 2 T1029 Specifications 1. Item No.: T1029 2. Model No.: SP0381 3. Battery Type: UL Certified Lithium Polymer battery 4. Battery Duration/Lifespan: 300 times 5. Battery/Cell Capacity: DC 3.7V / 10,000 mAh; 37Wh 6. Product Capacity (USB): DC 5V / 5,600 mAh; 28Wh 7.
  • Página 3 4 LED battery status indicator QI Certified wireless charging silicone dock Light up logo position T1029 Operation 1) ON: Press Power Button once 2) OFF: Press Power Button twice NOTE: The T1029 will automatically power OFF when inactive for approx. 60 seconds. To Recharge T1029 1) Insert the micro-USB output of the charging cable into the T1029 &...
  • Página 4: Fcc Statement

     To verify remaining battery percentage of T1029 press power button 4 blue LED (from left to right) indicates 100 – 75% battery power remaining 3 blue LED (from left to right) indicates 75 – 50% battery power remaining 2 blue LED (from left to right) indicates 50 – 25% battery power remaining 1 blue LED (from left to right) indicates 25 –...
  • Página 5 AVERTISSEMENT S'il vous plaît lire et suivre toutes les instructions et consignes de sécurité indiquées ci-dessous avant d'utiliser ce produit. De ne pas prendre ces précautions pourrait entraîner des blessures graves et/ou des dommages matériels. Précautions de sécurité  Veuillez lire les instructions avant d’utiliser le produit. ...
  • Página 6 Le T1029 est un chargeur sans fil certifié QI et UL 2056/UL2738 de 10,000 mAh. Ci-dessous les spécifications du produit et son mode d’emploi. Spécifications du T1029 1. Article Nº : T1029 2. Modèle Nº : SP0381 3. Type de batterie : Lithium polymère certifiée UL 4.
  • Página 7 Port de sortie USB (5V/2.1A CC) Bouton d’allumage ON/OFF 1 voyant LED (chargement sans fil) Voyant de niveau de batterie 4 LED Dock de recharge sans fil certifié QI Logo de position d’éclairage Fonctionnement du T1029 1) Allumage ON : Appuyer une fois sur le bouton d’allumage 2) Éteindre OFF : Appuyer deux fois sur le bouton d’allumage NOTE: Le T1029 s’éteindra automatiquement lorsque laissé...
  • Página 8: Déclaration De La Fcc

    4) Pour arrêter le chargement, appuyer deux fois sur le bouton allumage et débrancher le câble de chargement. NOTES:  Le logo demeurera allumé pendant le chargement de dispositifs. Appuyer deux fois sur le bouton d’allumage pour éteindre la lumière et les fonctions de chargement. ...
  • Página 9 ADVERTENCIA Por favor, lea y siga todas las instrucciones y precauciones de seguridad que se detallan a continuación antes de utilizar este producto. El no hacerlo puede traer como consecuencia lesiones personales graves y/o daños materiales. Precauciones de seguridad  Leer las instrucciones antes de utilizar el producto.
  • Página 10 El T1029 es un cargador inalámbrico UL 2056/UL2738 de 10,000 mAh con certificación QI. Ver especificaciones e instrucciones de uso del producto Especificaciones del T1029 1. Artículo Nº.: T1029 2. Modelo Nº.: SP0381 3. Tipo de batería: Polímero de litio certificada UL 4.
  • Página 11 Puerto de salida USB ( 5V/2.1A CC) Botón de encendido ON/OFF 1 indicador LED (indicador de carga inalámbrica) Indicadorres de nivel de batería 4 LED Dock de carga inalámbrico de silicona QI Logo iluminado de posición Funcionamiento del T1029 1) Encender: Oprimir una vez botón de encendido 2) Apagar: Oprimir dos veces botón de encendido NOTA: El T1029 se apaga automáticamente cuando está...
  • Página 12 NOTAS:  Logo iluminado permanecerá encendido durante la carga de dispositivos. Oprimir dos veces botón de encendido para apagar luz y desactivar función de carga.  Para verificar nivel de batería del T1029 oprimir botón de encendido 4 LED azul (de izquierda a derecha) señala 100 – 75% nivel de batería 3 LED azul (de izquierda a derecha) señala 75 –...

Este manual también es adecuado para:

Sp0381