Fellowes MS-450Cs Guia De Inicio Rapido página 4

OPERATION
Disconnect power switch must be in ON (I) position to operate shredder. Insert waste bag (Fellowes #36052) for easy disposal.
Continuous operation:
8-10-minute maximum
NOTE: Shredder runs briefly after
each pass to clear entry.
Continuous operation beyond
8-10-minutes will trigger a cool
down period to resume operation.
TROUBLESHOOTING
Paper jam: Set to Off (0) and empty bin. Replace bin and follow any or all of the below procedures.
Press and hold
Alternate slowly back and forth
Reverse ( )
ATTENTION: If the SafeSense ® light remains on, you must engage the
SafeSense ® feature. (See SafeSense ®
paper jam: If the SafeSense
SafeSense ®
paper. Warning – when switch is in override position, the SafeSense
function. Once the paper is cleared, reset the SafeSense
MAINTENANCE
Run regularly in reverse for
one minute
Oil when bin is full, or
immediately, if:
*Apply oil
Shredder stops running
across entry
WARRANTY
material and workmanship and provides service and support for 2 years from the date of purchase by the
original consumer. Fellowes warrants the cutting blades of the machine to be free from defects in material
and workmanship for 5 years from the date of purchase by the original consumer. If any part is found to
be defective during the warranty period, your sole and exclusive remedy will be repair or replacement,
mishandling, failure to comply with product usage standards, shredder operation using an improper power
supply (other than listed on the label), or unauthorized repair. Fellowes reserves the right to charge the
PAPER
Press Auto-On (I)
Set to Off (0)
CARD/CD
and plug in
Press Auto-On (I)
Set to Off (0)
and unplug
instructions below.)
feature activates (SafeSense
®
Override Switch to deactivate the SafeSense
® feature.
Follow oiling procedure below and repeat twice.
Press forward
*Only use a non-aerosol vegetable oil in long nozzle container such as Fellowes 35250
Hold card/CD at edge
Gently pull uncut paper
Press and hold
from paper entry. Plug in.
Reverse ( )
Override Switch
light remains on) to cause the user to think the
®
® feature and clear the
® light will flash and the SafeSense ® feature will NOT
Shred one sheet
consumers for any additional costs incurred by Fellowes to provide parts or services outside of the country
The duration, terms, and conditions of this warranty are valid worldwide, except where different limitations,
warranty, please contact us or your dealer.
Feed into paper entry
and release
Feed into card/CD entry
and release
Shredder doesn't start:
® active
Make sure bin is pushed in
Wait for motor to cool down
Sensor light illuminated–paper
SafeSense ® override switch
Active Not active
Press and hold Reverse ( )
2-3 seconds
Set to Off (0)
and unplug
not active
®
3