Publicidad
Idiomas disponibles
Idiomas disponibles
www.jts-germany.de
Please read these operating instruc -
ENGLISH
tions carefully prior to operation and
keep them and the attached frequency
list for later reference.
1 Applications
In combination with a receiver or several receivers of
the type TG-10R, the transmitter TG-10T creates a
mobile wireless system for speech transmission, e. g.
for guided tours or multilingual lectures. For wireless
transmission, the system uses 16 channels in the UHF
frequency range of 790 – 814 MHz. The transmission
range depends on local conditions and may reach
60 m as a maximum.
1.1 Conformity and approval of the transmitter
Herewith, MONACOR INTERNATIONAL declare that
the transmitter TG-10T is in accordance with the
basic requirements and the other relevant regulations
of the directive 1999 /5/ EC. The approval number is
.
This unit may be operated in the following countries:
DE
The regulations of the country where this transmitter is
operated must always be observed.
2 Important Notes
This unit corresponds to all required directives of the
EU and is therefore marked with
G
The unit is suitable for indoor use only. Protect it
against humidity and heat (admissible ambient tem-
perature range 0 – 40 °C).
G
For cleaning only use a dry, soft cloth; never use
water or chemicals.
G
No guarantee claims for the unit and no liability for
any resulting personal damage or material damage
will be accepted if the unit is used for other pur -
poses than originally intended, if it is not correctly
operated, or if it is not repaired in an expert way.
If the unit is to be put out of operation defin-
itively, take it to a local recycling plant for a
disposal which will not be harmful to the en-
vironment.
3 Power Supply
The transmitter /receiver is supplied with power via a
lithium-ion rechargeable battery: Prior to initial opera-
tion, fully recharge the battery. The following chargers
are available from JTS:
– charging station TG-10CH2 to recharge the batter-
ies of up to 2 units at the same time
– transport case TG-10CH18 to recharge the batteries
of up to 18 units at the same time
– transport case with castors TG-10CH36 to recharge
the batteries of up to 36 units at the same time
Do not put the unit in storage with a discharged bat-
tery. If the unit is not used for a longer period, recharge
the battery every three months.
As the unit must be opened for replacing the battery,
a defective battery must always be replaced by skilled
personnel. A suitable replacement battery from JTS is
available under the item number TG-3.7VB.
Defective rechargeable batteries must not be
placed in the household waste; always take
them to a special waste disposal.
Vertrieb von JTS-Produkten — Distribution of JTS products
4 Connecting the Microphone
to the Transmitter
When using the earband microphone instead of the
internal microphone (9), connect the earband micro-
phone to the jack MIC INPUT (1). Thus, the internal
microphone will be deactivated. If required, cover the
microphone cartridge with the pop shield provided.
Put the earband on your left ear so that the earlobe
support will press against your earlobe from the rear.
A clip is provided to attach the microphone cable to
your clothes.
5 Connecting the Earphone to the Receiver
As a padding for the earphone, wrap the foam cover
around it: Put the earphone with its printed side to the
rear into the unprinted pocket of the cover, wrap the
cover around the earphone and slip the second pock-
et over it. The printing
sound is emitted. Connect the earphone to the jack
(1) and attach the earphone to your ear.
For transmitting the sound to a hearing aid, con-
nect the induction loop NL-90 (available as an acces-
sory from MONACOR) instead of the earphone. Put
the loop around your neck. Via a magnetic field, it will
transmit the sound to hearing aids with a "telephone
coil".
6 Wearing the Unit
.
To wear the transmitter /receiver, attach the clip (5) to
your clothes (e. g. belt or trouser pocket) or use the
neckband:
7 Operation
1) To switch on the units of the system, press the but-
ton POWER (3). The POWER LED (4) will show
green. If it shows red, the battery is almost dis-
charged and should be recharged as soon as pos-
sible.
Whenever a button is pressed, the display (6)
will indicate the transmission channel adjusted for
approx. 9 seconds, then the channel number will
disappear. To reactivate the display for approx.
9 seconds, shortly press a button on the unit.
2) Select a transmission channel from the 16 channels
available (
the transmitter and the receiver /receivers of a sys-
tem to the same channel.
To set the channel, keep the button CHANNEL
(7) pressed until a dot starts flashing on the display
next to the channel number. Then press the button
CHANNEL repeatedly until the desired channel is
indicated. When the dot on the display disappears
approx. 6 seconds after the last actuation of the but-
ton CHANNEL, the channel selected has been
memorized.
3) Speak into the internal microphone (9) of the trans-
mitter or into the earband microphone connected.
®
Copyright
will mark the side where the
Pull the loop of the band over the
clip, slide the pushbutton to the
desired length of the band and put
the band around your neck. By
unlocking the snap connection
(
figure on the left), the unit is
easily removed and exchanged
against another one.
frequency list attached). Always set
©
by MONACOR INTERNATIONAL GmbH & Co. KG, Bremen, Germany. All rights reserved.
TG-10R
TG-10T
Tour Guide System
With the control (8), adjust the volume of the audio
signal transmitted on the transmitter and the repro-
duction volume on the receiver.
4) If the reception is poor, check
– if the reception can be improved by using a dif-
ferent transmission channel.
– if the transmitter and the receiver are too far
apart.
– if there are obstacles in the transmission path
which may shield the radio signal.
5) To reset a unit in case of malfunction, press the
button RESET (2) by means of a thin object, e. g. a
metal pin. The unit will be switched off and may be
set into operation again.
6) To switch off the units, keep the button POWER
pressed until the POWER LED is extinguished.
8 Specifications
Radio frequency range: 790 – 814 MHz, divided into 16 chan-
nels (
frequency list attached)
Audio frequency range: 40 Hz – 18 kHz
Transmitting power: . . . 10 mW
Internal microphone
of transmitter: . . . . . . . . electret microphone (cardioid)
Accessories
Transmitter: . . . . . . . electret earband microphone (omnidi-
rectional) with cable clip and 2 × pop
shield, neckband
Receiver: . . . . . . . . . dynamic mono earphone with padding,
neckband
Power supply: . . . . . . . lithium-ion battery 3.7 V/1300 mAh
Operating time
of battery: . . . . . . . . . . . up to 14 hours (depending on volume)
Dimensions, weight: . . 54 × 99 × 17 mm, 80 g
Subject to technical modification.
1
2
3
4
5
5
6 7
8
TG-10R
A-1126.98.01.06.2010
1
2
3
4
6 7
8
9
TG-10T
Publicidad
