Gnnetcom GN 9120 Manual Del Usuario página 8

Earhook (4) wearing style.
With an earhook, you can wear your headset on your right or left ear, according to
personal preference. Complete the following steps:
1. Rotate the boomarm 180 degrees.
Note: The boomarm cannot be rotated a full 360 degrees.
Do not force the boomarm when it cannot be rotated any further.
2. Detach the earhook ring, turn it 180 degrees and click it back on to the receiver.
3. Detach the earhook from the earhook clutch.
4. Insert the earhook into the opposite side of the earhook clutch.
Note: The buttons on the headset must be facing upwards.
Conference mode
Using the conference mode, more than one headset may be joined
to a telephone conversation via the base unit. The headset you use
with your base unit is the master headset.
1. Lift your master headset out of the base unit.
2. Initiate or answer a call. See the answering and making tele-
phone calls section.
3. During the telephone call, place an additional headset into the
base unit and leave it untill all lights stop fl ashing and only the
battery indicator is on. Remove the new headset from the base
unit - a beep will then be heard in the master headset, after
which you have 15 seconds to accept the additional headset.
4. Accept the additional headset by pressing the multifunction but-
ton momentarily.
5. An additional headset leaves the conference call by pressing its
multifunction button for 2 seconds.
8
GN9120_contents_usa_version 110403.indd 8-9
6. The conference mode is terminated when:
• the master headset is placed in the base unit
• or the master headset's multifunction button is pressed for 2 seconds
(this will end the call)
Note: Repeat steps 3-5 to add more headsets to the conference mode.
Up to 4 headsets may participate in the conference mode.
Answering and making telephone calls
Answering telephone calls:
To answer a telephone call:
1. Lift the telephone's handset out of its cradle when alerted to an
incoming call.
2. Remove the headset from the base unit. The link will be established
and the on-line indicator (1a) on the front of the base unit will light.
To end the call, place the headset in the base unit and replace the
telephone's handset to its cradle.
Making telephone calls:
To make a telephone call:
1. Remove the headset from the base unit. The link will be established
and the on-line indicator will light.
2. Lift the telephone's handset and listen for a dial tone in your head-
set.
3. Dial the desired number.
To end the call, simply lower your telephone's handset to its
cradle.
Note: If you connect the telephone connection cord to your telephone's headset sock-
et instead of the handset socket, this will enable the telephone's line button. You can
now answer and end calls by pressing the line button instead of using the handset.
Answering telephone calls using the GN 1000 RHL (Remote Handset Lifter):
You may purchase a GN 1000 RHL as an accessory, which lets you answer and
end telephone calls while away from your desk. Please contact your vendor or visit
www.gnnetcom.com for further information.
9
11-04-2003, 15:53:11