NINCOAIR Quadrone355 Manual Del Usuario página 8

On / Off indicator LED
Switch Charge / Off - On
Up & down (Speed) Left & Right (Direction)
Up & down (Forwards / backwards) Left & Righ (Crab)
Trim (Speed)
Trim (Direction)
Trim (Crab)
Trim (Forwards / backswards)
Antenna
Dual rate
INSTALLATION AND BATTERY CHARGE
Transmitter:
Switch in position OFF
1. Open the battery cover.
2. Fit the batteries (respect polarity).
3. Close battery cover. cuadruptero
BATTERY HELICOPTER CHARGE
1. Connect the plug of charger to the Battery.
2. Red LED will turn on. When the process finishes the LED will turn
off. (Charging time approx. 40-50 min).
3. Disconnect the plug. The flying time is 9-10 min..
HELICOPTER FLIGHT
Before flight:
1.- With the helicopter battery disconnected, switch ON the transmitter.
2.- Connect the helicopter battery.
3 .- Place the helicopter on the ground with the tail pointing toward you.
BINDING:
Helicopter and transmitter come linked from the factory.
If the helicopter LED flashes rapidly for 3 seconds and then remains fixed, when helicopter and transmitter are ON is that they are correctly
paired. If after 3 seconds blinking slowly, it is necessary to make the binding.
1. - Transmitter OFF.
2. - Insert the Li-Po in the helicopter and connect. The LED will flash 3 seconds. While blinking switch on the transmitter ON. The LED flashes
and beeps. When it stops beeping and the LED is solid red, the binding has ended.
8
NINCOAIR is brand of NINCO DESARROLLOS S.L.
Ctra. de l'Hospitalet 32
08940 Cornella Barcelona Spain
CIF B-60307725 · www.nincoair.com
HAND BOOK
ENGLISH