Capstone BJ-6 LED compact Instrucciones De Uso

One Year Limited Warranty
Capstone Industries Inc., warrants to the original retail purchaser,
this product to be free of defects in material and workmanship
for a period of up to one year from date of original purchase.
Warranty applies only to the original purchaser of the product.
Warranty is limited to consumer use and does not cover parts damaged due
to normal wear, abnormal conditions, misuse, or accidents, and is limited to
repair or replacement only.
This limited warranty does not cover bulbs or batteries, or any part that may
become defective due to mishandling.
Warranty is e ective only upon presentation of dated proof of purchase.
Limitations on Warranty Disclaimers
There are no warranties which extend beyond the description on the face
hereof. This warranty gives you speci c legal rights, and you may also have
other rights which may vary from state to state.
For assistance with assembly or installation, parts and customer service,
please do not return to retailer - contact Capstone CUSTOMER SERVICE at:
USA Toll Free: 1-888-570-8889 (English only)
Hours of Operation: Monday - Friday
9AM - 5PM ET
mail: info@capstoneindustries.com
website: www.capstoneindustries.com
Protecting the Environmant - Recycle It
Reponsibly recycling these products saves natural resources and protects
human health through reuse of reclaimed resources. Please call your local
waste management company for vendors in your immediate area.
OPERATING INSTRUCTIONS
Nightlight:
While in charging base, Nightlight automatically turns on
2 LED's when area gets dark. LED's turn o when area lights again.
Nightlight can not be turned o .
Power Failure Light:
Keep light plugged into AC outlet. While resting in charging base
4 LED's automatically turn on during power outage.
Hand-held Light:
Sliding the light out of the charging base automatically lights
the 4 LED's. Use the Control Button to adjust settings
(HI/LO/FLASHER/OFF).
Up to 4 hours of
power failure
lighting
WARNING
!
1. Close supervision is necessary when this unit is used near children.
2. Use only the charger supplied by the manufacturer to recharge.
3. To reduce the risk of electrical shock, do not put the unit in water or
other liquid. For cleaning, use a soft dry cloth. Do not place or store
appliance where it can fall or be pulled into a tub or sink.
4. TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER.
THERE ARE NO SERVICEABLE PARTS INSIDE.
3 IN 1 COMPACT
6 LED LIGHT
NIGHTLIGHT POWER FAILURE LIGHT HAND HELD LIGHT
IMPORTANT SAFETY INSTRUCTIONS
All of the safety and operating instructions should be read, adhered to and
followed before the unit is operated
SAVE THESE INSTRUCTIONS
PARTS AND SPECIFICATIONS
2 LEDs Nightlight - Automatically turns ON
-Charges internal rechargeable battery
Rotating AC plug ts in all electrical outlets
INITIAL CHARGE DIAGRAM 1
a) Rotate AC plug to t any electrical outlet.
b) Plug Induction Charging base upright in AC 120V - 60Hz wall socket and
place light into base. MUST BE CHARGED INDOORS.
c) Charge for one full day (24 hours) before rst use. Complete charging
time is 12 hours thereafter.
DIAGRAM 1 DIAGRAM 1
a) Rotate AC plug b) Insert base upright
to t into wall outlet
NOTE: This equipment has been tested and found to comply with the
limits for a Class B Digital Device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment o
and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the distance between the equipment and receiver.
- Connect the equipment to an outlet on a circuit di erent from that
to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This equipment complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions:
1) This device may not cause harmful interference.
2) This device must accept any interference received, including inter-
ference that may cause undesired operation.
Modi cations not authorized by the party responsible for compliance
could void user's authority to operate this equipment.
4 LEDs for Hand-held Light
and Power Failure
Auto Sensor - Detects darkness
for Nightlight Function
Control Button - Settings for
Hi/Lo/Flasher/O
when area gets dark
Induction Charging Base
-Charge lasts up to 4 hours
Charge for
24
HOURS
before rst use
MUST BE CHARGED INDOORS
c) Charge for 24 hours
before rst use