Maintenance; Anti-Dust Cap; Lubrication; Cleaning - HDX HDXBR50 Guía De Uso Y Mantenimiento

Maintenance

WARNING: Any time inspection, maintenance, and
cleaning are done:
Disconnect the tool from the air source.
Empty the magazine completely.

ANTI-DUST CAP

Each tool is packed with an anti-dust cap on the air
connector, check it after unpacking.
Keep the anti-dust cap covering the air connector when
the tool is not in use.

LUBRICATION

Frequent, but not excessive, lubrication is required for best
performance. Oil for the tool is added through the air line
connection and will lubricate the internal parts. Do not
use detergent oil or additives as these lubricants will
cause accelerated wear to the seals and bumpers in the
tool, resulting in poor tool performance and frequent tool
maintenance.
CAUTION: Lubricate tool with specified lubricants.

CLEANING

Avoid using solvents when cleaning plastic parts. Most
plastics are susceptible to damage from various types of
commercial solvents and maybe damaged by their use.
Use clean cloths to remove dirt, dust, oil, grease, etc.
WARNING: Do not at any time let brake fluids,
gasoline, petroleum-based products, penetration oils,
ect. come in contact with plastic parts. Chemicals
can damage, weaken or destroy plastic which may
result in serious personal injury.
COLD WEATHER
For cold weather operation, near and below freezing, the
moisture in the air line may freeze and prevent tool
operation. We recommend the use of air tool lubricant or
permanent antifreeze (ethylene glycol) as a cold weather
lubricant.
CAUTION: Do not store tools in a cold weather
environment to prevent frost or ice formation on the
tool's operating valves and mechanisms that could
cause tool failure .
12

Recommended hookup

1. The air compressor must be able to maintain a minimum
of 60 psi when the tool is being used. An inadequate air
supply can cause a loss of power and inconsistent
driving.
An oiler can be used to provide oil circulation through the
2.
tool. A filter can be used to remove liquid and solid
impurities which can rust or gum up internal parts of the
tool.
3. Always use air supply hoses with a minimum working
pressure rating equal to or greater than the pressure from
the power source if a regulator fails, or 150 psi, whichever
is greater. Use 3/8'' air hose for runs up to 50' and use a
3/8'' quick coupler on the air hose.
4. Use a pressure regulator on the compressor, with an
operating pressure of 0-125 psi. A pressure regulator is
required to control the operating pressure of the tool
between 60 psi and 100 psi.
Quick
coupler
Air hose
Quick
connector
CAUTION: The air compressor must be able to maintain
a minimum of 60 psi when the tool is being used. An
inadequate air supply can cause a loss of power and
inconsistent driving.
WARNING: Do not connect with air compressor which
can potentially exceed 200 psi. As tool may burst,
possibly causing injury.
Quick
Filter
Oiler
connector
Compressor
Quick
Regulator
coupler
HOMEDEPOT.COM
13
Please contact 1-800-514-6729 for further assistance.