Portable Metal Spike Light
Portable Outdoor Lighting
READ ALL INSTRUCTIONS
WARNING: When using portable luminaries basic safety precautions should always be followed
to reduce the risk of fire, electric shock, and personal injury, including the following...
A. Use only grounded extension cords UL rated for outdoor use such as SW, SW-A, SOW, SOW-A,
STW, STW-A, STOW, STOW-A, SJW, SJW-A, SJOW, SJOW-A, SJTW, SJTW-A, SJTOW, SJTOW-A,
SJTW, SJTW-A, SJTOW, SJTOW-A.
B. This product should only be plugged into a receptacle on a GFCI protected circuit or directly
into a GFCI outlet.
C. CAUTION: RISk OF FIRE - Space fixture housing and bulb a minimum of 2 inches from
surrounding structures.
D. CAUTION: RISk OF ELECTRIC SHOCk - Do not use with extension cord near water or where
water may pool. keep portable lamp holder at least 16 feet from pools and spas.
keep plugs and receptacles dry.
E. Maximum 150 watt Par 38 type bulb.
F. Do not exceed 100 feet from Spike Light to the GFCI protected outlet using 12-gauge
3-conductor extension cords.
INSTRUCTIONS:
S
1 (Positioning spike): Holding the spike light by the base of the spike or shroud,
tep
gently push the spike into the ground. The flat base of the spike should be at ground level
when finished. The spike should be vertical. In rocky or hard packed dirt, use a small trowel to
dig up rocks and loosen the soil where the fixture is to be place. Place the spike in the ground
and pack the dirt in and around it to secure it. DO NOT FORCE THE SPIkE INTO THE GROUND
AND DO NOT ATTEMPT TO HAMMER SPIkE INTO THE GROUND. Note: Take caution to aim the
light fixture left to right at this time. Aiming up and down will be done later.
S
2 (Bulb): Screw in Par38 Type bulb into fixture. Rubber gasket on shroud should contact
tep
bulb housing and create a seal when bulb is properly installed. Note: Bulb not to exceed 150
Watts. Outdoor rated, shatter resistant Par 38 bulbs are recommended.
S
3 (Cord): Plug power cord into grounded three prong extension cord. Proper
tep
ratings of extension cords are listed above.
S
4 (Aiming): Turn off power. Loosen adjustment screw on side. Tilt fixture up or down.
tep
Tighten adjustment screw. Restore power. Repeat if necessary.
PORTABLE
LUMINAIRE
SUITABLE FOR WET LOCATION USE
OUTDOOR USE ONLY
SL101B
Hubbell Electrical Products
A Division of Hubbell Incorporated (Delaware)
480-921-7552
www.hubbell-bell.com
Made in China/Hecho en China