Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Tool Tray
Caster Frame
Figure 2 - Assembling tool tray and casters
2. Assemble tool tray and five casters to caster frame
using Allen head binding barrels. Then attach two
creeper side frames to caster frame with two M8 x 60
hex head bolts, two washers and two acorn nuts
each (Fig 2).
Figure 3 - Attaching Creeper Seat
3. Attach creeper seat to creeper side frames using
two M6 x 40 Phillips head screws, with washers,
and nuts, and two M6 x 14 Phillips head screws as
in Figure 3.
Side Frame
WARNING
!
• Read, understand, and follow all instructions
before using this device.
• Never use a creeper/step stool that is damaged.
• Clean any mud, grease, oil or slippery liquids
before using creeper/step stool.
• Do not exceed rated capacity. Rated capacity is
300 lbs. (includes user, tools, and equipment).
• Sit down gently. Avoid shock loads caused by
jumping or falling on seat.
• Do not stand on seat.
• When used as a step stool, device must be on
firm, level surface with all four legs contacting
ground.
• Make sure step stool is appropriate height for
intended purpose. Do not overreach.
• Only one person shall use step stool at a time.
• Keep out of the reach of children. This device is
not appropriate for children's use.
• Use on smooth, level surfaces only.
Figure 4 - Attaching Step to Side Frames
4. Fasten creeper step to side frames using four M6 x 16
Phillips head screws (Fig. 4).
3
Creeper Step
Publicidad
Tabla de contenido
