Parts Diagram; Taking Measurements - METRICA 60459 Manual Del Usuario

Second function: Holding the shift button down and pressing the
Clear/Memory Clear button clears the currently displayed me-
mory.
Memory + / Next Memory
Adds the current measurement to the value in the selected
memory. The upper part of the display indicates the total value,
and the memory location selected (e.g. M1 is the first memory
location). Second function: Holding the shift button down and
pressing the Memory +/ Next Memory button selects the next
memory location (if M8 is selected, the next location is M1).
Memory - / Previous Memory
Subtracts the current measurement from the value in the se-
lected memory. The upper part of the display indicates the total
value, and the memory location selected (e.g. M8 is the eighth
memory location). Second function: Holding the shift button
down and pressing the Memory + / Previous Memory button
selects the previous memory location (if Ml is selected, the pre-
vious location is M8).
+ Wheel / Area
Adds the wheel radius (first press) or wheel diameter (second
press) to the current measurement, giving true wall-to-wall
distance. A third press resets this function, so that neither the
radius nor the diameter is included in the measurement. Second
function: Holding down the shift button and pressing the + wheel
/ Area button enters area calculation mode.

PARTS DIAGRAM

Upper housing
Lower housing
(other side, not shown)
Hubcap

TAKING MEASUREMENTS

1. Turn the measuring wheel on
2. Gently push the wheel forward along the distance to be mea-
sured. Keep the wheel in contact with the ground to be ensure
an accurate measurement
3. Distance can be read off the primary display, to add several
distances, use the [M+] button to store each length in memo-
ry or the [HOLD] function to preserve the measurement while
moving from one point to the next
4. To begin a new measurement, press the [cir] button
5. If measuring from wall, add the wheel radius by pressing
Pole clamp
Battery cover
Pole adjustment collar
Lower housing cap
(not shown)
Kickstand and spring
(not shown)
Handle with
handing eye