Checks And Maintenance; Spark Plug; Air Filter - Bohmer-AG i Serie Operación Manual

i Series

Checks and maintenance

Spark Plug

1. Remove spark plug cap and unscrew the spark
plug using the tool.
2. Carefully clean any carbon build-up on the tip.

Air filter

The air filter is installed on the intake system of the engine. It allows clean air to flow into the engine to
provide the correct air/fuel mixture.
To check/clean
1. Open generator side panel
2. Check air filter to ensure it is free of dirt build-up
3. If dirty, remove filter and clean with a solvent cleaning solution
4. Squeeze to remove water and allow to dry
5. Add a few drops of oil
6. Squeeze tight to distribute oil and remove any excess
7. Install air filter and cover
10
3. Check the gap using a gauge. The gap
should be between
4. Adjust as necessary then reinstall the
plug and cap taking care not to cross-
thread the spark plug.
© Böhmer-AG
English
0.7-0.8mm
.