Tripp-Lite SMART1524ET Hoja De Instrucciones página 5

Connector Cable
Assembly Instructions
4
Insert the RED crimped wire terminal into the RED DC connector
housing and the BLACK crimped wire terminal into the BLACK DC
connector housing. Then, join the connector housings together via the
slots on the housings. Be sure to observe the polarity.
RED
4
Equipment Connection Warnings
CAUTION: Make sure UPS is powered down and disconnected
from AC mains power. The battery circuitry is not isolated
from AC mains. Turn off power to the UPS prior to battery
connection.
Do not connect or disconnect battery modules while the UPS is operating.
Never attempt to install electrical equipment during a thunderstorm.
Make sure your external battery matches your UPS Rating: 24V or 48V.
External Battery Warnings
Connect the GREEN ground wire between an external metal battery cabinet
and the ground lug on the front of the UPS.
Connect the RED and BLACK cables to the external battery. Be sure to
observe the polarity: RED to the positive terminal and BLACK to the negative
terminal of the external battery.
BLACK
5