Westward 21A466 Instrucciones De Operación Y Manual página 6

Westward Operating Instructions and Manual
SETTING THE BEVEL CUTTING ANGLE
Bevel cutting angles may be adjusted up to 45°
towards the left or right. To adjust the bevel angle:
1. Loosen both base pivot screws (1) until the base
(2) can be rotated (Fig.2).
Fig.2
NOTE: Use the supplied 1/8" (3mm) hex key.
2. Bevel angles (3) are marked on a scale located
on the side of the base (Fig.3).
Fig.3
3. Slide the base toward the rear of the jigsaw and
align the bevel angle index mark (4) with the
desired bevel angle on the base.
4. Slide the base forward to engage the bevel angle
slot (5) with the indexing pin (6) (Fig.4)
Fig.4
NOTES: a) Use a protractor to check the bevel angle
between the blade and the base. b) To set the bevel
angle at intermediate angles, do not slide the base
forward.
5. Once the desired bevel angle is obtained, lock
the base by tightening base pivot screws.
6. Make a test cut in a scrap piece of material and
measure the bevel angle. Readjust the bevel
6.5A Orbital Jig Saw
6
angle if necessary.
SETTING THE ORBITAL CUTTING ANGLE
The variable orbital cutting action allows you to select
one of five different blade angles.
Position Angle
0 Neutral
I Small
II Medium
III Large
To set the orbital cutting angle, rotate the orbital
cutting lever forward or backward to the desired
setting number (1) (Fig.5).
Fig. 5
NOTE: The orbital setting button will "click" at each of
the four positions. Slide the orbital button slightly
forward or backward until it locks into place.
LASER
The LASER (1) is located in the front of the saw
housing (Fig. 6).
Fig.6
21A466
Material
Metal
Hard wood
Medium hard wood
Soft wood