Installation Notes; Product Use - Ecoflo RIVER Guía De Usuario

Batería adicional
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

Installation Notes:

1. The Extra Battery must be installed with RIVER before it can be used. It cannot be used by itself.
2. During the installation process, please pay attention to anti-static protection to ensure that there is
no static electricity from the operator or the environment. Static electricity may cause damage to the
product.
3. RIVER must be turned off before the installation process.
4. Tighten the screws to ensure the Extra Battery is firmly attached to RIVER.

Product Use:

1. DO NOT expose the product to any liquids. Do not immerse the product in water. DO NOT leave the
batteries out in the rain or near a source of moisture. Moisture in the device could cause short circuits,
component failure, fires or even an explosion.
2. Never use non-EcoFlow parts. Go to http://www.EcoFlow.com to purchase new parts. EcoFlow takes
no responsibility for any damage caused by the use of non-EcoFlow parts.
3. Never install or remove other modules from the RIVER when it is turned on. DO NOT plug or unplug
other modules when the power of the product is turned on, otherwise the power interface may be dam-
aged.
4. The product should be used in temperatures between -4ºF and 140ºF (-20°C and 60°C). The use of
the product in environments above 140ºF (60°C) may cause fires or explosions. The use of the product
below -4ºF (-20°C) will severely affect the performance of the product. Allow the product to return to a
normal operating temperature before using it.
5. DO NOT use the batteries in strong electrostatic or electromagnetic environments. Otherwise, the
battery control board may malfunction and cause a serious accident during use.
6. Never disassemble or pierce the product in any way. Otherwise, it may leak, catch on fire, or explode.
7. DO NOT use the product if it was involved in a crash, accident, or a heavy fall.
8. If the product falls into the water during use, take the product out immediately and put it in a safe
and open area. Keep a safe distance from it until it is completely dry. Never use it again and dispose
it properly as described in the Battery Disposal section below. If the product catches fire, it is recom-
mended to use fire extinguishing equipment in the following order: water or water mist, sand, fire blan-
ket, dry powder fire extinguisher, and a carbon dioxide fire extinguisher.
9. DO NOT put the device in a microwave oven or in a pressurized container.

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido