Publicidad
Idiomas disponibles
Idiomas disponibles
Before assembling your product, please take a few minutes to check the contents and become familiar with all the parts.
HOW TO INFLATE
1. Take the product out of box, and make sure all parts are included.
2. Fill water into the Base through the Drain Plug; the volume can be around 1/3 of the space. Seal the plug.
3. Inflate the Base and Horizontal Body through the other Air Valves.
4. Then seal the valve with valve lid, and press the valve into the unit to get a flat surface.
5. Connect the garden hose with the water hose connector.
NOTE: Do not use air compressor to inflate, or the product will be easily
destroyed. If the valve cannot be recessed into the unit, it may be an
indication of overinflation. Pinch valve at its base with fingers to let the
air out, then seal the valve with the valve cap, and press the valve into
the unit to get a flat surface.
HOW TO DEFLATE
Pull the valve outwards. Open the valve cap and pinch the valve
base to let out the air. When all the air has been released,
replace the cap on the valve.
Keep away from small children - small parts, choking hazard.
HOSE CONNECTION INSTRUCTIONS
For products with water sprayers or hose connectivity,
tighten the threaded hose connector to a standard
garden hose. Slowly turn the water on, and adjust to
your desired speed of rotating (if applicable).
Threaded Hose
Connector
1. To Clean: rinse with lukewarm mild soapy water and hang to dry. Never iron or brush. Do not clean with solvent cleaning agents - this will damage
the product permanently.
2. Do not drag while the product is loaded, or sharp objects can puncture.
3. To Repair: clean the repair area. Press the included repair patch firmly over the puncture/hole/leak, then wait for 30min before re-inflating.
IMPORTANT: Do not modify this product or use any parts and accessories not supplied by the manufacturer. Replace defective parts according to
the instructions of manufacturer.
4. To Drain: remove all accessories, garden hose and toys (if any). Deflate the pool, then remove the drain valve stopper and drain. You can also
push the sidewall down and inwards to empty the pool completely.
5. To Store: deflate, drain and completely air-dry the product. Gently fold, and store in a dry place away from direct sunlight. The original packing
carton can be used for storage.
2
SETUP INSTRUCTIONS
Garden Hose
MAINTENANCE & STORAGE
OWNER'S MANUAL
Water Spray
Water Hose
Connector
Air Valve
Drain Plug
For products with a Quick-Connect mechanism, tighten the
mechanism between the threaded hose connector and a
standard garden hose.
Threaded Hose
Connector
Quick-Connect
Air Valve
Drain Plug
Air Valve
Garden Hose
Publicidad
