Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY OF POWER TOWER™ MODEL P10300:
1. Place cart on a level surface.
2. Insert mast in mast holder on cart and tighten mast locking knob.
3. Insert fixture mount into inner mast and insert safety snap pin through holes.
4. Route power cord through cord retaining ring near base of mast.
Fixture Mount
Inner Mast
Mast Holder and Mast
Locking Knob
OPERATING INSTRUCTIONS:
1. Place the light base on a flat stable surface and set the wheel brake.
2. Use sandbags or anchors to stabilize the unit for outdoor applications.
3. Make sure the cord is properly attached to the base of the light to prevent a trip hazard.
4. Plug the light into a properly grounded circuit. Use a GFCI protected circuit for outdoor use.
5. Adjust the light head fixture to desired angles.
6. Carefully extend the light heads to the maximum height. Be aware of overhead power lines. Use caution to control the mast to prevent the mast from dropping
and injuring the user. Make sure the mast lock tab is in place.
7. Turn on the switch that is mounted on the lower mast section.
Power Cord Retaining
Ring and Storage
Safety Snap Pin
2
Publicidad
