Solter AUTONOMY 3500 Manual Del Usuario página 5

2. CHARGING:
Connect the adaptor into main supply and the minor plug into the charging socket in the back
panel on the AUTONOMY 3500. Five LED illuminating means starting charging. The volt of
the internal battery rise up to 14.5V and stay on this charging level course is isobaric. When
the internal battery is full charged and the LED will keep lighting. Charging time usually need
to last 48 hours.
It also can be charged from 12V DC resource from your vehicle with the supplied DC cord
with two cigarette lighter plugs.
This method can only charge the battery to approx. 50% of its capacity.
3. CHECK BATTERY:
Put on the "TEST" button to check the internal battery status. All five LED illuminating means
the internal battery is good and full. If only the RED LED illuminate, the AUTONOMY 3500
need recharge.
4. DC POWER RESOURCE:
The Jumpstart is also a portable power source for all 12VDC accessories equipped with a
male cigar lighter plug. The DC outlet has automatic overload protection (15amp max).
Recommended inverter for the portable source is 150 watts max.
CAUTION:
1. Do not use the battery if the cable or plug is damaged. To avoid damage of cable and
plug, never pull the cable to disconnect the charger.
2. Repairs should be carried out by experts only. Otherwise it may cause considerable
danger for user.
3. Avoid short circuit of the product:
Don't touch the poles by any conductive material.
Don't store the battery in a box in which the poles might touch other objects.
4. Don't store AUTONOMY 3500 in places in which the temperature could exceed 50º.
MI03045-04