Connect The Speakers; Adjust The Volume - Logitech Z906 Guia De Instalacion

CONNECT THE SPEAKERS

Make sure that speakers, control console, and audio source are all POWERED OFF before you begin system setup
1 Connect the speaker cables:
Connect each satellite to its corresponding plug (red or black) on the subwoofer back panel Push the tab
on the spring clip, insert the wire into the connector, and release the tab
2 Connect the audio source cable:
Turn off the speakers Connect your audio source (e g , TV, DVD, computer) to the appropriate input jack
on your subwoofer
• For computer sound cards, use the 6-channel input 1 (cable included)
• To connect to analog outputs, use the stereo RCA input 2 or the auxiliary input on the side of
the control console (cables not included)
• To connect to digital outputs, use the two optical inputs and the coaxial input 3, 4, 5 (cables not included)
1

ADJUST THE VOLUME

1 Power on the speakers Set volume to the nine o'clock position to test
Adjust the volume by turning the control knob to the left or right
2 You can also adjust the volume on the remote control by pressing the +/- buttons
1
INPUT DECODE
1
2
STEREO
3
4 3D
5 4.5
AUX 2.1
INPUT EFFECT
3 4 5
REAR LEFT
REAR RIGHT
FRONT LEFT
FRONT RIGHT
CENTER
MUTE LEVEL
2
1
2
2
1
2
3 4
5
3 4 5
INPUT MUTE
LEVEL
EFFECT
English 5