Accutire MS-51GB Manual De Instrucciones

then displays result on
mobile devices such as Ipad or Smartphone.
-104°F ~ 185°F, -40°C ~ 85°C
1
With the included cable tires, mount the
, and make sure that
APP for the Monitor and the APP Functions.
Note: The signal can be received to 10 meters / 30 feet
approximately (provided there is no block between signal
source and receiver) If the handheld device is too far from the
monitor, or the monitor does not start, APP interface will show
unconnected status.
2
APP Function as following:
1. Show Voltage
)
V 11.7V to
11．9V, yellow icon means battery is not good, below 11.5V, red
b) this
c)
This means
the device is running and charging the battery. If the voltage is
alternator or the connection between the battery and alternator.
d)
APP shows battery voltage below 2.4V, you should change
the backup CR2032 battery in the Monitor.
2. Show Temperature — F/C
F/C
3. "Life" - Indicates the remaining life of the battery.
4. Show cycles within a period.
5. Monitor the voltage in real time.
Warning Message Setting
Click the icon on the top right corner to enter "setting", select
"warning message setting"
3
140°F
-4°F ~ 32°F, -20 °C ~ 0°C
10°F
Set the CR2032 battery low voltage limit, backup battery
voltage value: 2.4V
Warning message: YOUR COIN CELL IS LOWER THAN 2.4V
Note: The warning message is only received when the Bluetooth
function of the mobile device is switched on and within range,
connected with Battery Monitor
Warranty and Service
Measurement Ltd., Inc. warrants this product against defects in
material or workmanship for a period of one (1) year from the
date of purchase and agrees to replace it. This warranty does not
cover damage resulting from misuse or abuse of the product.
Should your product require service, you may send it back to
Measurement Ltd., Inc. for repair or replacement.
FCC STATEMENT :
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received,
including interference that may cause undesired operation.
Warning: Changes or modifications not expressly approved
by the party responsible for compliance could void the user's
authority to operate the equipment.
4
NOTE: This equipment has been tested and found to
comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference
in a residential installation.
This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there is no
guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and
receiver.
- Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician
for help.
RF warning statement:
The device has been evaluated to meet general RF
exposure requirement. The device can be used in portable
exposure condition without restriction.
5