Installation Procedure
10. Apply a bead of the color-matched 100% silicone
sealant (included in the kit) on the top edges of the
bench seat. Also apply a bead of the
color-matched 100% silicone sealant under the
front edge of the seat panel.
The installation is now complete. DO NOT
discard these installation instructions. PLEASE
LEAVE THEM WITH THE HOMEOWNER.
The Swan Corporation – Swanstone
Maintenance & Surface Repair
Care and Cleaning
The Swanstone products are stain and abrasion
resistant; however, the finish requires reasonable care.
Because cleaning products change over time, always
check the manufacturer's instructions to make sure it is
compatible with plastic. DO NOT use a cleaner if the
label indicates it should not be used on plastics. DO NOT
use spray-on cleaners that require daily use without
immediately rinsing with water to stop the chemical
cleaning reaction because damage will result and void the
warranty.
Day-To-Day Cleanup
Simply wipe the surfaces with a clean towel to remove
watermarks and residues. All Swanstone products can
be cleaned with warm water, a soft cloth, and normal
household detergents or cleansers, such as Fantastic,
Formula 409, Clorox Clean-up, Handy Andy, Mr. Clean,
K-FC-001
or Lestoil. Always rinse off cleaners within five minutes
of application.
Occasional scrubbing with household abrasive cleaners
ensures that the original luster is maintained.
Caulking Joints
Inspect caulking joints monthly for damage or any signs
of separation from the mating surface. Cracks in the
caulking will allow water to leak into the surrounding
surfaces. Reapply caulking to any joint showing
signs of wear or cracking. Failure to inspect and
repair caulking joints will void the warranty.
Surface Repair
Light Scratches
Use 400 grit sandpaper to remove light scratches in the
surface.
Deep Scratches or Gouges
For deeper scratches or gouges, use 220 or 320 grit
sandpaper. A "Scotchbright pad" can be used to blend
the repair into the surrounding area.
10
IMPORTANT NOTICE
800-325-7008