Operating Instructions - Sticker Mule LMD03 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

6. Operating instructions

Insert the power jack plug
dedicated socket
plug to the electrical socket.
Before turning on the device, load the roll of labels fol-
lowing the procedure described in chapter 7.
Press the power button
device will make three acoustic signals of increasing
volume to warn that the dispenser is ready for use and
both LEDs will be lit.
The switched on device will be in MANUAL mode. To
change the MANUAL/AUTOMATIC mode, see chapter 10
"Mode of operation".
Configure the optical sensor (see chapter 9).
To peel the label in MANUAL mode, press button
Once the label has been removed, press button
again for the next label.
In case of AUTOMATIC mode, press button
peeling. Once the label has been removed, the dispenser
will peel off the next label.
as far as it goes into the
and connect the power supply
to start the device. The
.
to start
English |
9
EN
FR
ES
DE
IT

Publicidad

Tabla de contenido
loading

Tabla de contenido