Gate Operation - Evenflo WALK-THRU Manual Del Usuario

Gate Installation
D
Cardboard Cover
D
6
8. Turn both upper adjustment bumpers
and both lower adjustment
D
bumpers , as shown, until all four
D
contact the door frame or mounting
caps.
Check that the gate is still straight up
and down then turn each bumper two
more full rotations or until tight.
9. Test to make sure the gate frame
D
assembly is secure by firmly shaking it.
If it moves, it needs to be re-installed.
Repeat steps 8 – 9.
WARNING
BEFORE removing the CARDBOARD
COVER and cutting the PLASTIC TIE,
ENSURE the gate is securely in place or
serious injury may result.
Plastic Tie
10. With your gate securely in place,
remove the cardboard cover, then cut
and discard the plastic tie.
D
11. Adjust both upper bumpers
the gap between the handle
latch is 1/8 in. (3.2 mm).
K
12. Inspect the gate. Make sure it swings
freely and latches securely.
J 1/8 in.
K
(3.2 mm)
L
L
J
M
until
D
and
J
Full Green
Indicator N.
13. When using at the top or bottom of
stairs, pivot the swing stop
the locked position on the opposite
side of the gate from the stairs. This
will prevent opening the gate into the
stairway. In all other locations, pivot the
swing stop down to the locked position
on the side of the gate that the child
occupies.
14. To open gate, slide and hold release
button
and swing gate open.
15. To close gate, gently push gate closed.
16. When indicator
latched. When indicator is red, gate is
NOT latched.
N
3

Gate Operation

down to
L
. Lift up on gate handle
M J
is green, gate is
N
7