Removing & Cleaning The Roller Brush - djive Vacumate One Manual Del Usuario

REMOVING AND CLEANING
THE ROLLER BRUSH \\\
1. Make sure that you do not press the ON switch.
2. Disconnect the motorised floor brush unit from the suction tube or
handle unit and turn the cleaning attachment over so that the bottom of the
cleaning head is facing you.
3. Before replacing, make sure that both the roller brush and the cleaning
attachment are completely dry.
4. To remove the roller brush, press the release button on the side of the hou-
sing and remove the brush for cleaning. Now remove hair wrapped around
the brush and fluff from the roller brush and at the sides of the suspension.
Also clean the brush shaft.
5. First, slide the roller brush back onto the clip in the motorised floor brush.
The other end cap should face up with the straight side of the suspension
rail. Gently push the roller brush down the suspension rail until it snaps into
place with an audible "click".
28
ATTENTION
Disconnect the brush attachment from the
cordless vacuum cleaner at the beginning