Horizon Global 76509 Instrucciones De Instalación página 3

Always wear SAFETY GLASSES
when installing hitch
Figure 3
Using flat head
screwdriver
Figure 2
1. Remove underbody panels:
a) Using flat head screwdriver and pry bar, remove (6) plastic rivets from rear underbody panel, see Figure 2. Return the rear panel to vehicle owner.
b) Using flat head screwdriver and pry bar, remove (5) plastic rivets from passenger side underbody panel, see Figure 3. Keep it for reinstallation.
2. Install hitch: Raise hitch into position and loosely install (3) M10 bolts ① and (3) conical washers ②, both sides, see Figure 1.
3. Tighten all M10 fasteners with torque wrench to 42 Ft.-Lb. (57 N*M).
Proper torque is needed to keep the hitch secure to the vehicle when towing.
4. Reinstall passenger side underbody panel.
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to prevent entry of water and exhaust fumes. A hitch or ball which has been damaged
should be removed and replaced. Observe safety precautions when working beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch. This product complies with safety specifications and requirements for
connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5 and SAE J684.
©2021 Horizon Global™ Corp - Printed in Mexico
Installation Instructions
PART NUMBERS: 76509, 84509, CQT76509
①②
Using pry bar
①②
②
①
①
②
Existing Weldnuts
Frame Rails
Figure 1
Sheet 3 of 12 76509NP
Fastener Kit: 76509F
Qty. (6) Hex Bolts
M10 X 1.25 X 35 CL 8.8
Qty. (6) Conical washer
3/8"
Conical washer
teeth side
against hitch
Fasteners
typical
both sides
06-09-21 Rev. A