Brandson Equipment 304258 Manual Del Usuario página 14

6. Manual operation
1. To start manual watering, set the duration to ON.
2. To stop manual watering, set the duration to OFF.
After finishing the manual mode, set the duration back to the desired settings.
7. Additional safety instructions
• The timer is water resistant, NOT water proof. The timer has to be installed
above ground and vertically to the tap. Do not immerse the device in water!
• DO NOT pull the hose when it is connected to the watering control system to
avoid damage to the timer
• This timer is intended for outdoor use, to control watering systems.
• The device should not be used for industrial purposes
• The water pressure is between 0 bar and 8 bar (0 psi to 116 psi).
Use it only with clean water and fresh water, the water temperature has to be
above 1°C and below 60°C.
• Protect the timer during winter season or from frost. Disassemble the device
from the tap and drain all the water from it. Remove the batteries and keep the
device and the batteries safely at home.
• Always keep the cover closed to prevent water from entering.
• Do not use the device if it has fallen down or has been subject to impact.
• Ensure that you clean the filter regularly if it is dirty.
8. Cleaning
Clean the filter in the water tap connection regularly to prevent your watering
system computer from clogging.
14
English