Trilite MV2IND-110P Guia De Inicio Rapido

IMPORTANT SAFETY INFORMATION
CAUTION! The individual user should determine prior to use whether this device is
suitable, adequate or safe for the use intended. Since individual applications are
subject to great variation, the manufacturer makes no representation or warranty
as to the fit or suitability of these devices for any specific application.
CAUTION! Ensure that the power supply matches the voltage rating of the light.
VOLTAGE: 120 VAC, .25A Max, 60 HZ.
IMPORTANT: In order for this unit to be water resistant it must be installed as pictured, with the dome facing upward.
It may be installed in any orientation if not used outdoors or in damp locations.
Installation:
1. Select a suitable mounting location. Use ENT connector provided if pipe mounting the warning light.
When installing, be sure that the power is off.
2. Provide a 1/4" diameter hole in the mounting surface for the threaded rod attached to the center of the base.
Route wire through drill hole according to preferred wiring method.
3. WIRING THROUGH HOUSING: Drill a 7/16" hole in the mounting surface within the footprint of the base, install
the provided rubber grommet. Feed power wire(s) through this grommet to protect them.
WIRING THROUGH PERIMETER OF BASE: Remove the plastic plug and replace it with the provided grommet.
Use the same method to feed the power wires through the mounting surface.
4. Wiring convention indicates connecting "hot" to black wire and "neutral" to white. Secure connection and check
for proper operation.
5. Reassemble the internal light mechanism and dome.
REPLACEMENT PARTS LIST
Part# Description
200503 Amber Dome
200506 Blue Dome
200509 Clear Dome
200505 Green Dome
200502 Red Dome
203211 Purple Dome
LIMITED WARRANTY
If it appears within one (1) year from date of delivery to Purchaser that any products or component parts do not conform exactly to the specifications and physical
dimensions referred to above, and the Purchaser, at its expense, returns the product or component parts to the Seller together with a report of defects, the Seller shall
review the inspection report and inspect the items and shall authorize, at its option, either the repair or replacement of any non-conforming products or component parts.
Upon expiration of the warranty period, all liability of the Seller shall be terminated.
This product may be used with a Tri Lite Mars brand LED bulb, warranted to be free from defects in materials and/or workmanship for (3) three years from the date of
delivery to Purchaser. The Limited Warranty does not apply to severe applications.
Seller shall not be liable for any injury, loss or damage, direct or consequential arising out of the use or the ability to use the product. This warranty gives specific legal
rights. You may have other rights, which vary from state to state. Some states do not allow the exclusion or limitation of incidental or consequential damages, so that
the above limitation of exclusion may not apply to you.
info@triliteinc.com | t: 1-773-384-7765 | f: 1-773-384-5115 | www.triliteinc.com | Designers and manufacturers of specialty electrical products. Since 1922.
INSTALLATION INSTRUCTIONS
for MV2IND-110P WARNING LIGHT
Part# Description
203311 Base
410403 1/2" EMT Fitting
420705 Lamp, 25 Watt, 120 volt, dual contact, bayonet base
426012 LED Lamp, 3 Watt, 120 volt, dual contact, bayonet base
500505 Motor, 120 volt, 60 Hz, 80 rpm
953027 | REV B