Setting The Sleep Timer; Playback Modes - Veho AZURO Guia De Inicio Rapido

6. Setting the sleep timer

You can set the Azuro to enter standby mode after a certain amount
of time. Whilst in any of the playback modes press the SLEEP button
on the remote control repeatedly to cycle through the sleep time
options. You can choose between 90, 80, 70, 60, 50, 40, 30, 20, 10,
5 and 3 minutes. Select 00 if you do not want the sleep timer to be
set. The Azuro will enter standby mode after it has been on for the
desired amount of time.

7. Playback modes

To enter the playback modes press the standby button, then press the
MODE button to repeatedly cycle through the available modes. You
can choose between FM, LINE, AUX, USB, CARD, OPT in or BT. Press
the standby button to enter standby mode again. When you press
the standby button
to enter playback
modes the Azuro
will automatically be
on the last playback
mode that you used.
Please note: If there is no
audio signal for 60 minutes
the Azuro will automatically
enter standby mode.
FM
The FM mode on the Azuro is the FM radio. Press the TUNE/SKIP
buttons on the remote to tune to a radio station. Press and hold
the TUNE/SKIP buttons to auto search for radio stations. When an
available station is found the Azuro will stop searching. You can also
use the numbers on the remote to select the required frequency, for
example press 8, 9 and 9 to go to 89.9 MHz.
To store your favourite radio stations press the MEM button on the
remote so that a programme number starts to flash. Use the CH+
or CH- button to select your preferred programme number for the
current radio station. Confirm your selection by pressing the MEM
button on the remote. To go to a stored radio station whilst in FM
mode press the CH+ or CH- buttons.