Safety Precautions And Maintenance Rules - Pro 40 Serie Manual De Operación

7. "START" button The button starts:
-counting
-continues counting and clears error
messages on display 2
-clears counting result on the main dis-
play 1
-stores changes to the counter settings
8. "BTH" button
Mode switch button (100, 50, 25, 20,
10, reset):
Press "BTH" several times depending
on the necessary amount of banknotes,
when necessary to change the desired
total by a smaller amount, use button
"+1"-adds 1 package of counting.
Chosen number of banknotes will be
indicated on display in the mode.
Figure 2
5

Safety precautions and maintenance rules.

• Read this manual before operation
The manual should be available to operator
• The device should be installed on an even horizontal surface, away from water and
dangerous objects
• Don't place the device in an area where it can be affected by direct sunlight,
directional artificial light, strong vibration, or dust
• Do not operate the device with wet hands
• Do not expose to water (or other liquid)
• Avoid foreign objects
• Avoid dropping the device
• During operation:
When finished be sure there are no banknotes in the hopper or transport system
• Clean the device regularly and service the device as needed at a licensed service
center
• Do not disassemble, repair or attempt to update the counter on your own. This can
result in damage to the device or injury to the operator. Contact a licensed service cen-
ter in case of failure
• Do not turn on the counter if the power cord is damaged
• If the device was exposed to cold for an extensive period of time, it is necessary to
keep it at the room temperature for no less than 4 hours
Remember! The producer is in no way responsible for damage to the device or injury to
the operator in the event of incorrect operation /care of the device.
16