Craftsman 580.752420 Instrucciones De Uso página 19

ChangBng Engine Oil
Change engine oilafterthefirst5 hoursandevery
50hoursthereafter. If youareusingyourpressure
washer u nderextremely d irtyor dustyconditions, or in
extremely h otweather, c hange oil moreoften.
CAUTION
• Used motor oil has been shown to cause skin cancer in
certain laboratory animars,
• Thoroughly wash exposed areas with soap and water,
KEEP OUT OF REACH OF CHILDREN.
DON'T POLLUTE. CONSERVE
RESOURCES. RETURN USED OiL TO
COLLECTION CENTERS.
Change oil while engBne is still warm from running, as
follows:
1. Drain fuel tank by running pressure washer until
fuel tank is empty.
2. Disconnect spark plug wire and keep it away from
spark plug.
3. Clean area around oil fill, remove oil fill
cap/dipstick. Wipe dipstick clean.
4. Tip your pressure washer to drain oil from oil fill
into a suitable container making sure you tip your
unit away from spark plug. When crankcase is
empty, return pressure washer to upright position.
5. Slowly pour recommended oil (about 22 oz.) into
oil fill opening. Pause to permit oil to settle. Fill to
"Full" mark on dipstick.
6. Wipe dipstick clean each time oil level is checked.
DO NOT overfill.
7. Replace and tighten dipstick.
8. Wipe up any remaining oil.
9. Reconnect spark plug wire to spark plug.
Service Air CReaner
Your engine will not run properly and may be
damaged if you run it with a dirty air cleaner.
Service the air cleaner once every 25 hours of
operation or once each year, whichever comes first.
Service more often if operating under dirty or dusty
conditions. Replacements are available at your local
Sears service center.
To serv{ce the air cleaner, follow these steps:
1. Loosen two screws and lift off cover.
Two Screws
Cover
Cartridge
Base
2. Carefully remove air cleaner from base.
3. Install clean (or new) air cleaner in base. Air
cleaner must fit securely in base.
4. Place cover over air cleaner and tighten screws.
NOTE: You can purchase new air filter elements by
calling 1-800-4-MY-HOME (469-4663).
Service Spark P_ug
Service the spark plug every 100 hours of operation or
yearly, whichever occurs first.
1. Clean area around spark plug.
2. Remove and inspect spark plug.
3. Replace spark plug if electrodes are worn, or if
insulator is cracked or chipped.
4. For replacement use either the standard resistor
spark plug, Champion RC12YC or the long life
platinum spark plug, Champion RC12PYP.
5. Check electrode gap with wire feeler gauge and
set gap at 0.020 inches (0.50mm), if necessary.
\
6. Install spark plug, tighten securely.
NOTE: You can purchase a new spark plug by calling
1-800-4-MY-HOME (469-4663).
19