Clearing A Sheet Jam; Troubleshooting; Manufacturing Locations; Technical Support - Codonics Horizon GS Manual Del Usuario

5. Slide the pick tire off of the spindle.
6. On the new pick tire, locate the two notches on one side of the pick tire, shown in the
following figure. These notches fit over two small pins on either side of the spindle.
7. Orienting the pick tire with the notched side first, slide the pick tire all the way on to the
spindle, making sure you align the notches with the spindle pins.
8. With the clip tab facing away from the pick tire, slide the retaining clip sideways back onto
the spindle.
9. Use a cleaning wipe provided with the Platen and Print Head Cleaning kit or use the Horizon
Cleaning Cassette to clean the pick tire of any oil from your fingers.

Clearing a Sheet Jam

With the latest versions of the imager, the sheet path through the imager has been simplified, since
there is only one receive tray. Other than the simplified path, clearing a sheet jam is the same as with
previous versions of the hardware.

Troubleshooting

For the latest versions of the imager, there is a new reason for a sheet jam: A sheet jam can occur if the
print head is in the shipping position when attempting to print. To correct this problem, remove the
jammed sheet and move the print head to the printing position (see "Changing the Print Head
Position").

Manufacturing Locations

Horizon Imagers are manufactured in both the USA and China. Refer to the product label at the rear of
the imager to determine the origin of your imager.

Technical Support

If problems occur that are not covered by this Addendum, please contact Codonics Technical Support
at any time.
Phone: +1.440.243.1198
Email: support@codonics.com
Website: www.codonics.com