EN
Dear customer, thank you for purchasing one of our Uniteck products. Please read all instructions carefully
before using the product.
UNICONNECT 1.6
To connect the panel/controller/battery, we recommend that you use the Uniconnect 1.6 ready-to-use
kit, which optimizes your electrical performance and simplifies installation.
The Uniconnect kit is equipped with flexible solar cable with tinned copper core. They are resistant to
extreme conditions (-40°C- to 120°C). With a cross-section of 6 mm², they optimize the useful power of
your installation by guaranteeing you a minimum voltage drop.
They can be easily and quickly connected to the panels using their MC4 connector. They are equipped
with a fuse kit to protect your installation and battery and are supplied with a UV-resistant waterproof
roof pass, battery terminals and cable guides.
COMPOSITION
Uniconnect is composed of:
•
2 x 8 m of 6mm² black and red solar cables with fast solar connectors to connect the panel(s) to
the controller.
•
Waterproof and UV-resistant roof and wall pass.
•
A battery connection kit, composed of 2 x 2 m of 6mm² black and red solar cables to connect the
regulator to the battery, a fuse protection kit to protect the installation from any battery
malfunctions and battery terminals as well as terminal covers.
SAFETY INSTRUCTIONS
•
Take appropriate measures to prevent accidents during your assembly work.
•
If the bracket and mounting material are exposed to sunlight for a long period of time, there is a
risk of burning. Protect yourself.
•
At the end of the work, check that your supports and panels are securely fastened.
For the proper functioning of the controller, please observe the following order of connection:
To disconnect, please proceed in reverse order. For more information, refer to the user manual of your
charge controller.
8/19
Controller connection > battery
Panel connection > controller
Controller connection > electrical consumer
www.uniteck.fr