Steren CCTV-965 Guía Rápida página 5

We recommend to use a HDD as master
Make sure that the hard drive jumper is in master mode
CONNECTIONS
1.- Locate the BNC input jacks on the rear of the video recorder.
2.- Connect the #1 camera in the BNC input jack labeled as CH1.
Use this same process for up to four cameras if you wish.
in the channel 1 and 2 can connect 2 audio cameras and use the
audio ports 1 and 2 respectively.
3.- Connect a monitor to one of the BNC output jacks labeled as
VIDEO OUTPUT or VGA port.
4.- If you use a LAN network the connect a network cable in the LAN
port from DVR.
5.- In the USB port you can connect a USB device for backup files
VGA MONITOR
VIDEO
AUDIO
MONITOR
AUDIO CAMERA 2
NETWORK
6.- If you wish to connect a PTZ camera, movement sensor and an
alarm, connect it to RS485, sensor and alarm input jack.
MOTION SENSOR
PTZ CAMERA
7.- Insert the power adaptor to the input labeled DC and the other
end to the electrical outlet.
ENGLISH-03
AUDIO CAMERA 1
CAMERA 3
CAMERA 4
ALARM
SYSTEM BOOT
Turn on the monitor after turn on the DVR. After you turn the equip-
ment the system will boot up and automatically detects the new HDD,
if the HDD is new in screen will appear the following:
If the HDD is used in screen will appear the following:
We recommend formatting the hard drive first, remember to
format the hard disk will lose all information (if you have infor-
mation) on your hard disk.
Press SELECT button to format.
When to end in screen will appear the following:
Then the display shows the four cameras with date and time.
RECORDING
In order to begin recording, follow these steps:
1.- Power the device on and setup whatever is necessary (Enable
cameras of recording, quality video, speed, date and time, etc.) For
more information you can consult the main menu.
2.- To begin to record press rec button.
3.- To stop the recording press the stop button.
PLAYBACK
Once the recording has finished, you can begin the playback of the
recorded files.
Press the play button after
press menu button, the new
screen will be the next:
Select a event and press play button
ENGLISH-04