Reset Procedure; Transmitter Battery - Duratech PLP-REM-350 Manual De Instrucciones

RESET procedure

RESET procedure for the control board
1) Make sure the PLP-REM-350 is powered ON
2) Press and hold the RESET button on the logic board
3) The blue LED will light up
4) Release the RESET button when the blue LED turns off
The control board has been RESET.
!
And all transmitters have been unpaired.

Transmitter battery

Replacing transmitter battery:
• Remove the philips head screw and open the transmitter
• Replace the battery, respecting the polarity
Battery type: A23 12V
16
DuraLink
Blue
LED
RESET
button
+