Technical Data - BGS technic 9825 Manual De Instrucciones

TECHNICAL DATA

Spreading width: 20-110 mm
Operating pressure: 5-8 Bar (72-116PSI)
Max. pressure: 8 bar (116 PSI)
Compressed air inlet: 1/4" BSP
Weight: 2.2 kg
COMPONENTS
1 Air inlet
IMPORTANT INFORMATION
• Make sure that the CV boot to be mounted is soft and flexible, otherwise it will tear during
expansion. Do not expand the CV boot more than necessary.
• Always wear safety glasses and suitable working gloves when using this tool.
• Never reach between the expansion arms!
• Never exceed the max. working pressure of 8 bar.
OPERATION
1. Put the CV boot over the expansion arms (4)
of the tool. Ensure that the CV boot is firmly
seated on the expansion arms.
2. Actuate expansion valve (2) to expand the CV
boot to the required size.
3. Slide tool with expanded CV boot over drive
shaft joint.
4. Actuate the release valve (3) to close the
expansion arms (4).
5. Slide the CV boot off the released expansion
arms (4).
6. Actuate the expansion valve (2) to open the
expansion arms and pull the tool over the
drive shaft joint.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
CV Boot Air Assembly Tool
2 Expansion valve
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
3 Release valve
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
BGS 9825
4 Expansion arms