How It Works - Cooper Lighting MS180 Manual De Instrucciones

MS180_W 825-0216.qxd:MS180 325-1553.qxd
Congratulations! You have purchased a Cooper Lighting, LLC motion activated
detector for outdoor lighting. When installed properly, this sensor will provide
years of convenience and protection for your home and family.

How it works

Your motion activated detector senses heat
from objects such as people, large animals and
automobile engines. When motion is detected, the
lights connected to the detector will automatically
turn on. Once motion has stopped, the lights will
automatically turn off after a preselected
time delay. With your motion activated
detector attached, you may also control
your lights manually from the wall switch.
What you need
• Phillips screwdriver
• Outdoor weatherproof silicone caulking
• 1, 2, or 3-hole junction box coverplate (A)
What's included
• Motion detector (B)
• (3) Wire nuts (C)
Common wall and eave mounting applications
What to know
• cULus Listed for wet location use.
• This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation. Under Part 15 of
the FCC Rules, any changes or modifications to the motion detector
described in this instruction sheet that are not expressly approved by Cooper
Lighting, LLC could void the user's authority to operate the equipment.
Call for customer service and/or missing or damaged parts (800-334-6871)
6/26/08 2:58 PM Page 2
MS180, CMS180 (Bronze)
MS180W, CMS180W (White)
180 degrees
2
A
B
C