Publicidad
1
ASSEMBLY
Included with your KYTEs are two rear feet
and four Pozi 2 screws. These are required to
install the rear foot on each speaker (you will
need a PZ2/Pozi 2 screwdriver). Simply hand
tighten two screws through each of the feet
into the corresponding threaded holes on the
back of the speaker (as shown in the diagram).
To ensure the foot is aligned correctly, place
the speaker with foot attached on a flat surface
before fully tightening to ensure the speaker will
sit level in its final position.
IMPORTANT: NEVER place the speaker face
down when fitting the feet to avoid damage to
the drive units.
An optional metal base is available for purchase,
which will offer greater compatibility with a
wide range of third party loudspeaker stands
(see www.rega.co.uk for details).
CONNECTION
Ensure the colour terminals Red (+) and Black
(-) are connected to the correct terminals at
both loudspeaker and amplifier binding posts.
We recommend using good quality loudspeaker
cable such as the Rega 'Duet'. Always use the
same length speaker cable to each loudspeaker.
POSITIONING
The KYTEs can be used on stands, a sturdy
shelf or flat surface. Imaging and bass response
can be tuned by adjusting the distance of the
speaker from the rear and side walls. As with all
loudspeakers, this will be dependant on the size
of room, flooring and furnishings therefore some
simple experiments trying different distances
will help optimise the performance to your
surroundings. In general more bass is produced
if the cabinet is positioned closer to a structural
wall.
REPLACING THE DRIVE UNITS
In the unlikely event a drive unit needs to be
replaced it is necessary to remove the front
fascia label to access the drive unit fixing
screws. A new adhesive front panel label will
be supplied as standard with any replacement
units. To remove the front panel label, we
recommend accessing via the unit that requires
replacement to prevent damage to the phenolic
cabinet. We recommend that any servicing is
carried out via your Rega dealer.
www.rega.co.uk
MADE IN ENGLAND
Publicidad
