Tripp-Lite B320-4X1-HH-K1 Manual Del Propietário página 14

Installation
RS-232 Commands
Command
Sw1 x1
Sw2 x1
Sw3 x1
Sw4 x1
PWD
STE
Important note control command:
Only one command can be issued at a time. You must wait for the switch to
accept and finish the first command before sending a second. If a second
command is sent/issued before the first is completed, the switch will ignore the
second command.
20-05-025-933CA4.indb 14 20-05-025-933CA4.indb 14
Commands for Serial Control
Meaning
Routed to Output1, Output n to input [x1]
Routed to Output1, Output n to input [x1]
Routed to Output1, Output n to input [x1]
Routed to Output1, Output n to input [x1]
Stands for Power On/Off
State of the output
14
10/21/2020 9:26:39 AM 10/21/2020 9:26:39 AM