Acuity Brands Lighting JunoConnect Instrucciones De Instalación

WARNING:
For your safety, read and understand instructions completely before starting installation. Before wiring to power supply, turn off electricity at the fuse
or circuit breaker box.
NOTE:
Juno products are designed to meet the latest NEC requirements and are classified in compliance with applicable UL standards. Before
attempting installation of any recessed lighting product, check your local electrical building code. This code sets the wiring standards and installation
requirements for your locality and should be understood before starting work.
SAVE THESE INSTRUCTIONS
P
roduct Information
The round and square 4" and 6" JunoConnect™ downlight provides high-quality light output and efficiency while eliminating the need for recessed housings. The
innovative, slim design allows for easy retrofit, remodel or new construction installation from below the ceiling. Connects from any Apple or Android phone to the
JunoConnect directly using Bluetooth
TM
The JunoConnect TM downlight consists of the following: LED module, remote driver box and installation instructions. Check for all contents prior to installation.
Optional Items: New Construction Plate, Joist Bar Kit, and Extension Cable (6ft, 10ft, and 20ft) see www.acuitybrands.com for more details.
Do not make or alter any open holes in an enclosure of wiring or electrical components during kit installation.
WARNING
- Risk of fire or electric shock.
•
Do not alter, relocate, or remove wiring, lampholders, power supply, or any other electrical component.
•
Installation of this retrofit assembly requires a person familiar with the construction and operation of the luminaire's electrical system and the hazard involved. If not qualified,
do not attempt installation. Contact qualified electrician.
•
Install this kit only in luminaires that have the construction features and dimensions described in these instructions, and where the input rating of the retrofit kit does not
exceed the input rating of the luminaire.
WARNING
- To prevent wiring damage or abrasion, do not expose wiring to edges of sheet metal or other sharp objects.
THIS RETROFIT KIT IS ACCEPTED AS A COMPONENT OF A LUMINAIRE WHERE THE SUITABILITY OF THE COMBINATION SHALL BE DETERMINED BY CSA OR
AUTHORITIES HAVING JURISDICTION.
FCC Supplier's Declaration of Conformity
Juno WF4C RD TUWH MW and WF6C RD TUWH MW. This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may
cause undesired operation.
Suppliers Name: Acuity Brands Lighting, Inc.
Suppliers Address (USA): One Lithonia Way | Conyers, GA 30010
Suppliers phone number: 800.323.5068
Caution:
The user is cautioned that changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to
operate the device.
Note:
This device has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential installation. This device generates uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this device does cause harmful interference to radio or television reception, which can be determined by
turning the device off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the device into an outlet on a circuit different from that to which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
This device complies with FCC radiation exposure limits set forth for an uncontrolled environment. This device should be installed and operated with a minimum
distance of 20cm between the radiator and any part of your body.
This device contains license-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada's licence-exempt RSS(s).
Operation is subject to the following two conditions:
(1)
This device may not cause interference; and
(2)
This device must accept any interference, including interference that may cause undesired operation of the device.
L'émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR d'Innovation, Sciences et Développement économique Canada
applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes:
(1)
L'appareil ne doit pas produire de brouillage;
(2)
L'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.
This device complies with ISED RSS-102 radiation exposure limits set forth for an uncontrolled environment. This device should be installed and operated with a
minimum distance of 20cm between the radiator and any part of your body.
Pour se conformer aux exigences de conformité CNR 102 RF exposition, une distance de séparation d'au moins 20 cm doit être maintenue entre l'antenne de cet
appareil ettoutes les personnes.
RF RADIATION EXPOSURE STATEMENT:
environment. This device should be installed and operated with a minimum distance of 20cm between the device and any part of the user's body.
Pour se conformer aux exigences de conformité CNR 102 RF exposition, une distance de séparation d'au moins 20 cm doit être maintenue entre l'antenne de cet
appareil ettoutes les personnes.
Only for 5G Devices
The devices for the band 5150-5350 MHz are only for indoor use.
Les appareils de la bande 5150-5350 mhz ne sont conçus que pour une utilisation en intérieur.
One Lithonia Way, Conyers, GA 30010 • Phone: (800) 705-SERV (7378) • Visit us at www.acuitybrands.com
©2020 Acuity Brands Lighting, Inc
INSTALLATION INSTRUCTIONS
and free download of the SmartThings
®
This device complies with FCC and ISED RSS-102 radiation exposure limits set forth for an uncontrolled
Rev 09/20
JunoConnect
App.
®
®
(Bluetooth / Zigbee
TM
®
)
1 of 2