How Does Marmitek X-10 Work; Signal Range - Marmitek TM13 Modo De Empleo

HOW DOES MARMITEK X-10 WORK?

Marmitek X-10 components use the existing mains wiring to communicate (using
Marmitek X-10 signals). You can build a complete system using the three different kind
of components of the Marmitek X-10 System:
1. Modules:
2. Controllers:
3. Transmitters: Wireless components like remotes. The signals of these
ADDRESSES
Up to a maximum of 256 different addresses can be preset. These are subdivided into
a so-called HouseCode (A to P incl.) and a UnitCode (1 to 16 incl.). The HouseCode can
also be set on the controllers, so that the controllers and modules become part of the
same system. The address can be set either using code dials or by pressing buttons,
depending on the type of module.
The Marmitek X-10 System uses standard commands, which control all units with the
same HouseCode at the same time (e.g. all lights on, all off, etc.).

SIGNAL RANGE

Range of Marmitek X-10 signals over the Power Line and how to increase
the range.
The Marmitek X-10 System is based on power line communication. The range of the
Marmitek X-10 signals very much depends on the local circumstances. On average
the range is a cable length of 80 meters.
If you have difficulties with the range of your Marmitek X-10 signals,
please pay attention to the following facts:
1. When more than one phase is used for your electrical system, it is necessary to cou-
ple these phases for the Marmitek X-10 signals. For coupling you can use FD10
Phase Couplers/Filters. You only need to install a Phase Coupler/Filter when your wall
outlets and light switches are divided over more than one phase (more than one
group is no problem). For bigger buildings or longer distances we advice you to use
an active repeater instead of passive FD10's.
4
These components will receive Marmitek X-10 signals and will
switch or dim the attached lamp or appliance.
These components will transmit Marmitek X-10 signals and thus
will control the Modules.
components will be received by a controller with transceiver
functionality (IRRF 7243, TM13 or console of a Marmitek Security
System). The Transceiver will translate the signals into Marmitek
X-10 signals on the power line.
© MARMITEK