Notice - BlissLights Ark Manual Del Usuario

NOTICE

CAUTION—Use of controls or adjustments or performance of procedures other than those
specified herein may result in hazardous radiation exposure.
This device complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.
This product is classified as a Class 3R laser product and complies with the applicable parts
of IEC/EN 60825-1 Ed. 2.0:2007 and Ed. 3.0:2014. The manufacturer additionally certifies it
complies with the US FDA Federal Laser Product Performance Standard (FLPPS) provided in
21 CFR Subchapter J, 1040.10 and 1040.11 except for allowable deviations specified in FDA
Guidance documents.
Do not stare into the beams emitted from the product. Intentional long term viewing
of CLASS 3R levels of laser light can be hazardous. This product uses diffractive optics
to scatter the beam energy. This scattering effect causes the energy concentration to
drop below the exposure limits for momentary or accidental viewing at a relatively short
distance from the laser aperture. As with all bright light-sources, when you operate this
device in unsupervised general public areas, it is recommended that up-close access to the
light be restricted or prevented and the beams be directed into locations were persons are
not expected.
This laser display device incorporates a CLASS 3B laser system which, by itself, may be
hazardous. However, this laser display product incorporates a protective housing and
diffractive optics in its design so that there is no exposure or human access to laser
radiation during operation or maintenance above the CLASS 3R limits. Each individual laser
beamlet's power is below the Class 3R limit of 5 mW.
UNDER NO CIRCUMSTANCES shall attempts be made to open the protective housing or
operate the device if the aperture window is damaged.
All service to this laser display device requiring the protective housing to be opened and/
or removed shall be performed by service personnel or their authorized agents. Opening
the protective housing voids the warranty.
NO LASERS SHOULD BE POINTED INTO THE SKY WITHIN 10 NAUTICAL MILES
(18.5 km) OF AN AIRPORT. IF YOU ARE LOCATED WITHIN THIS SPECIFIC PERIMETER, WE
RECOMMEND THE LASERS BE POINTED DOWN AT THE GROUND SO NO STRAY BEAMS
ARE PROJECTED INTO THE AIR. CHECK WITH YOUR LOCAL AIRPORT OR PROVINCIAL
GUIDELINES FOR FURTHER INFORMATION.
1