2- Remove the bolt indicated in Image 2 in both sides of the
motorcycle and keep it for the crashbars installa!on.
Image 2
4- Start by installing the le" side bar in the same point removed
in Image 1. Use the TC1, TC6, BJ1 hardware and the original
bushing removed in Step 1, as indicated in Image 4 and Diagram.
* No!ce that the original bushing from Step 1, has to be installed
a"er the bushing BJ1.
Image 4
A!er the installa"on of the parts, please check that they are aligned and that all the hardware is properly "ghtened
Calle 76 # 52D - 74 / Telefax: (57+4) 448 8428 / Medellín - Colombia
BMW 1200 WATER COOLED 13-UP
3- Install PL1 and PL2 plates in both sides of the motorcycle
respectevely as indicaten in Image 3. Use TC2, TC7 and TC10
hardware as indicated in the Diagram.
*Do not !ghten un!l the installion is concluded.
5- Install de lower back part from the le" side bar, with the
original hardware of the motorcycle removed in Step 2, as
indicated in Image 5.
Imagen 5
Image 5
www.mastechno.com
Image 3