ENFORCER SM-433-TQ/W Manual De Instrucciones

SM-433-TQ/W
SM-433-TQ/B
Concealed-Terminal Adhesive
Surface-Mount
Manual
SM-433-TQ/W shown
Installation:
Please read manual before the installation.
1. Mount the contact above the door or
window on the frame. For doors, ensure
that the mounting is farthest from the
hinged side of the door.
2. Connect two wires to the contact
terminals and to the alarm control panel.
3. Mount the magnet on the door/window so
that it will face the contact. Be sure that
the gap between the contact and magnet
does not exceed 1
NOTES:
Contact and magnet must be installed on
1.
the protected side of the door or window.
Spacers are included for difficult or
2.
misaligned installations.
WARRANTY: This SECO-LARM product is warranted against defects in material and workmanship while used in normal service
for one (1) year from the date of sale to the original customer.
NOTICE:
The SECO-LARM policy is one of continual development and improvement. For that reason, SECO-LARM reserves the right to change
specifications without notice. SECO-LARM is also not responsible for misprints. All trademarks are the property of SECO-LARM U.S.A., Inc. or their
respective owners. Copyright © 2019 SECO-LARM U.S.A., Inc. All rights reserved.
SECO-LARM
16842 Millikan Avenue, Irvine, CA 92606
Phone: (949) 261-2999 | (800) 662-0800 Email: sales@seco-larm.com
/ " (31mm).
1
4
U.S.A., Inc.
®
Features:
 Surface-mount magnetic contacts
 Adhesive mount
 Gold-plated terminals for longer expected life and
reliability
 Screw terminals
 Cover hides mounting screws, terminal block, and
wires
 Contact reed switch is SPST, iridium-plated
 For closed loop circuits
 1
/ " (31mm) Gap
1
4
 Double-sided tape included
 Lifetime limited warranty
Parts List:
10x Contact Switches
1x Manual
Protected side of door
Website: www.seco-larm.com
10x Magnets
Alarm
Control
Panel
Hinge side
of door
®
PITSW1
MI_SM-433-TQx_190418_ML.docx