Energizer 59326-T1 Manual De Instrucciones

Remote Control Puck Lights
BATTERY INSTALLATION
Puck: To open, twist back cover of puck light counterclockwise
and remove. Insert 3 AAA batteries per puck (noting polarity). To
close, replace cover and twist clockwise.
IMPORTANT: Different types of batteries or new and used batteries
should not be mixed. Exhausted batteries should be removed from the
fixture and disposed of properly.
Remote: To replace exhausted battery, remove the screw and
cover, on the back of the remote. Insert 2 CR2032 batteries,
noting polarity. Replace the cover and screw.
Note: Remove battery isolation tab before first time use.
MOUNTING INSTRUCTIONS:
1. Remove back cover and use pre-
installed double-sided tape to mount
in desired location.
Note: For a more permanent
installation, screw through the two
holes using counter sunk screws.
Note: Ensure one of the two wireless icons (
unobstructed and facing desired direction for remote to reach
interior sensor. The remote will work better with direct line of
sight access to the wireless icons (
2. Reattach light to mounted back cover by aligning tabs and
twisting clockwise.
Note: Back cover may remain mounted when
changing batteries.
Screw holes
) remains
).
REMOTE OPERATION:
1. On the remote, press the ON button
to turn the lights on, or press the OFF
button to turn them off.
2. Use the + and - buttons to brighten or
dim the lights.
3. The 10%, 40%, 80% and 100% buttons
allow you to go directly to your desired
output level
4. The 10min, 30min, 60min and 120min
buttons automatically turn the lights off
after the number of minutes indicated
on the button.
Note: When using the remote, point
directly at the puck for proper operation.
MANUAL OPERATION:
1. First press: turns the light on
2. Second press: turns light off
Functional range may be adversely affected by one or more of
the following factors: weather, radio frequency interference, low
battery or obstructions between the transmitter and receiver.
MADE IN CHINA/HECHO EN CHINA
©2021 Energizer. Energizer and certain graphic designs are
trademarks of Energizer Brands, LLC and related subsidiaries
and are used under license by Jasco Products Company, LLC.
Contact our U.S.-based Consumer Care at 1-800-654-8483
between 7AM-8PM CST.
90-day warranty. Visit www.byjasco.com for warranty details.
READ IT OR WATCH IT
R
ead instRuctions oR watch
- - .
easy to follow video
s QR
can code oR visit
. /59326
byjasco com i
59326 EnSp Manual v1
12/10/20 MS