SECO-LARM ENFORCER SM-205Q/W Manual

SM-205Q/W
SM-205Q/BR
Miniature Surface-Mount Contacts
Manual
SM-205Q/BR shown
Installation:
Please read the manual carefully before
:
beginning installation.
1. Mount the contact above the door or
window on the frame. For doors, ensure
that the mounting is farthest from the
hinged side of the door.
2. Connect two wires to the contact
terminals and to the alarm control panel.
3. Mount the magnet on the door/window so
that it will face the contact. Be sure that
the gap between the contact and magnet
does not exceed
NOTES:
Contact and magnet must be installed on
1.
the protected side of the door or window.
Spacers are included for difficult or
2.
misaligned installations.
LIFETIME LIMITED WARRANTY:
SECO-LARM's obligation is limited to the repair or replacement of any defective part if the unit is returned, transportation prepaid, to SECO-LARM. Under no circumstances will SECO-LARM be
responsible for any costs or charges for removal, installation, or reinstallation. This Warranty is void if damage is caused by or attributed to acts of God, physical or electrical misuse or abuse,
neglect, repair, or alteration, improper or abnormal usage, or faulty installation, or if for any other reason SECO-LARM determines that such equipment is not operating properly as a result of causes
other than defects in material and workmanship. The sole obligation of SECO-LARM, and the purchaser's exclusive remedy, shall be limited to repair or replacement only, at SECO-LARM's option.
In no event shall SECO-LARM be liable for any special, collateral, incidental, or consequential personal or property damages of any kind to the purchaser or anyone else. This lifetime limited
warranty is for products sold and installed in the United States and Canada. For all other countries the warranty is 1 (one) year.
NOTICE:
The SECO-LARM policy is one of continual development and improvement. For that reason, SECO-LARM reserves the right to change specifications without notice. SECO-LARM is also
not responsible for misprints. All trademarks are the property of SECO-LARM U.S.A., Inc. or their respective owners. Copyright © 2019 SECO-LARM U.S.A., Inc. All rights reserved.
SECO-LARM
16842 Millikan Avenue, Irvine, CA 92606
Phone: (949) 261-2999 | (800) 662-0800 Email: sales@seco-larm.com
/ " (19mm).
3
4
This SECO-LARM product is warranted against defects in material and workmanship while used in normal service for the lifetime of the product.
U.S.A., Inc.
®
Features:
 Miniature "flange-type" surface-mount magnetic contacts
perfect for sliding doors and windows where space is limited
 Screw or adhesive mount
 Mounting flange breaks off for extra miniature size
 High-impact weatherproof ABS plastic case
 Contact reed switch is SPST, deactivated rhodium on gold
underplating for a longer expected life
 For closed loop circuits

/ " (19mm) Gap
3
4
 15" (38cm) Wire leads extend from side of switch
 Double-sided tape included
 Lifetime limited warranty
Parts List:
10x Contact Switches
Type:S
1x Manual
49J5
Protected side of door
Website: www.seco-larm.com
10x Magnets
Alarm
Control
Panel
Hinge side
of door
®
PITSW1
MI_SM-205Qxx_190620_ML.docx