Helpful Tips; Cleaning & Maintenance; Filter Replacement - Homecraft HCAPTBC31FUVBK Instrucciones

• The UV lamp can be visually displayed by blue light when it is working.
• The blue light on the UV button will flash continuously
indicating that it is time to replace the filter.
• After the filter replacement is completed, push and hold the UV
button for 3 seconds to reset filter change indicator.

HELPFUL TIPS

PROBLEM
Purifier cannot run
The effect is bad
to eliminate smoke
and odor
Filter cleaning ligh
does not extinguish
It is hard to eliminate
the odor and smoke
CLEANING & MAINTENANCE
Please take care of your AIR PURIFIER by following these simple cleaning directions.
CLEANING
• It is recommended to clean the filter twice a week with soft brush or household vacuum cleaner.
• Do not use water to wash the filter.

FILTER REPLACEMENT

• Refer to INSTALLATION.
• After the filter replacement is completed, push and hold the UV
button for 3 seconds to reset filter change indicator.
7
REASONS
-It is possible that the power
cord is not plugged in or poor
contact with power cord
- Power switch may be off
- It is possible that the filter
is not installed in place and
safety switch is not triggered
- It is possible that the filter
assembly is not installed
well
- It is possible that the filter
assembly has reached the
end of life
- It is possible that the air
inlet is blocked by foreign
matter
- It may be that the "UV"
button is not long
pressed for 3 seconds after the filter
assembly is replaced.
- It may be that the filter
assembly is also wrapped
in a packaging bag
SOLUTIONS
- Please reconnect power cord
- Please turn on the power
switch
- Please properly install the
filter and buckle the back
cover (reference to page 6)
- Please properly install the
filter assembly
- Please replace the new
filter assembly
- Please remove foreign
matter from the air inlet
After cleaning the filter
assembly, press the "UV"
button for 3 seconds
-Please remove the
packaging bag outside the
filter assembly