Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 62

ASSEMBLY

STEP 1
Align the XZ gantry to the base, make sure the connector is perfectly
aligned to the female connector on the base.
STEP 2
The M5 screws used to fasten the XZ gantry to the base are pre-inserted
into the extrusion, use the Allen key provided to tighten the screws.
Push the aluminum extrusions against the inside of the slot when tight-
ening the screws.
- 8 -

Publicidad

Tabla de contenido
loading

Tabla de contenido