Phoenix Gold Z Serie Guia De Inicio Rapido página 3

Z-Series Component Speakers
WARNING
Do not drill mounting holes with speaker in place as this could allow drill shavings to damage the
voice coil and void the speaker warranty.
TWEETER (Surface/Angle Mount)
To obtain the best performance from the tweeter it should be located on axis to approximately
4" below the rear view mirror. Select the mount you require and use this as a template to drill
the holes to mount or alternatively if using an adhesive pad ensure the mounting surface is
cleaned with a residue free cleaner and attach the speaker using the adhesive pad. Attach
the wires to the speaker terminals.
TWEETER (Flush Mount)
Ensure you have adequate depth to mount the tweeter and cut a 50mm hole. Assemble
the rear mount with the spring clamp and press through from the rear of the hole, then
attach the front plate to the rear plate. Attach the wires to the speaker terminals.
CONTENTS
2 x Phoenix Gold Component Speakers
2 x Phoenix Gold Tweeters with wires
2 x Phoenix Gold Speaker Grilles
1 x Mounting Template
8 x Mounting Screws
1 x User Manual
WARNING:
Audio Systems can produce sound levels over 135dB. Continuous exposure to sound pressure levels over 100dB
may cause permanent hearing loss. Please watch for emergency vehicles as warning signals may not be heard.
NOTE
Speaker Wire included with the
component speaker system will only
connect the tweeter to the speaker,
additional wiring is needed to
connect to the audio system.
© 2017 Phoenix Gold • www.phoenixgold.com
Z5CS - Z65CS