Página 1
Order toll-free in the U.S.: Call 877-877-BBOX (outside U.S. call 724-746-5500) FREE technical support 24 hours a day, 7 days a week: Call 724-746-5500 or fax 724-746-0746 Mailing address: Black Box Corporation, 1000 Park Drive, Lawrence, PA 15055-1018 Web site: www.blackbox.com • E-mail: info@blackbox.com...
1-TO-2 COMPOSITE VIDEO SPLITTER/1-TO-2 S-VIDEO SPLITTER NORMAS OFICIALES MEXICANAS (NOM) ELECTRICAL SAFETY STATEMENT INSTRUCCIONES DE SEGURIDAD 1. Todas las instrucciones de seguridad y operación deberán ser leídas antes de que el aparato eléctrico sea operado. 2. Las instrucciones de seguridad y operación deberán ser guardadas para referencia futura.
Página 3
1-TO-2 COMPOSITE VIDEO SPLITTER/1-TO-2 S-VIDEO SPLITTER 10. El equipo eléctrico deber ser situado fuera del alcance de fuentes de calor como radiadores, registros de calor, estufas u otros aparatos (incluyendo amplificadores) que producen calor. 11. El aparato eléctrico deberá ser connectado a una fuente de poder sólo del tipo descrito en el instructivo de operación, o como se indique en el aparato.
Página 4
1-TO-2 COMPOSITE VIDEO SPLITTER/1-TO-2 S-VIDEO SPLITTER TRADEMARKS USED IN THIS MANUAL Any trademarks mentioned in this manual are acknowledged to be the property of the trademark owners.
Página 5
Video Types: AC176A: Composite video; AC177A: S-Video Video Standards: NTSC, PAL, SECAM Video Level: 0.5–1.5 Vpp Connectors: AC176A: Input: Composite: (1) BNC F, Output: (2) BNC F; AC177A: Input: S-Video (1) 4-pin mini-DIN F, Output: (2) 4-pin mini-DIN F Power: 110 VAC, 60 Hz, wallmount Size: 1.75"H (1U) x 6.4"W x 6"D (4.4 x 16.3 x 15.2 cm)
Página 6
1-TO-2 COMPOSITE VIDEO SPLITTER/1-TO-2 S-VIDEO SPLITTER 2. Introduction 2.1 Overview Use the 1-to-2 Composite Video Splitter or the 1-to-2 S-Video Splitter to send a single video signal to two displays or to boost signal strength over long coax runs. A typical application is shown in Figure 2-1. Camera Figure 2-1.
Página 7
1-TO-2 COMPOSITE VIDEO SPLITTER/1-TO-2 S-VIDEO SPLITTER 2.2 Connectors Figures 2-2 and 2-3 show the rear-panel connectors on the 1-to-2 S-Video Splitter and 1-to-2 Composite Video Splitter. Following each illustration is a description of each connector’s function. ❷ ❸ ❶ Figure 2-2. 1-to-2 S-Video Splitter (AC177A) connectors. Input: This S-Video connector accepts the input signal.
Página 8
1-TO-2 COMPOSITE VIDEO SPLITTER/1-TO-2 S-VIDEO SPLITTER ❷ ❸ ❶ Figure 2-3. 1-to-2 Composite Video Splitter (AC176A) connectors. Input: This female BNC connector accepts the input signal. Outputs: Use these female BNC connectors to connect display devices. AC Input: Power in accepts 12 VAC from a wallmount...
Página 9
1-TO-2 COMPOSITE VIDEO SPLITTER/1-TO-2 S-VIDEO SPLITTER 3. Installation and Operation IMPORTANT! Turn off all equipment before connecting or removing cable connections. 1. Connect the video source signal (such as a video camera) to the video splitter’s input connector. 2. Connect the display sources (such as a TV, VCR, or monitor) to the video splitter’s output connectors.