Preparation For Mounting - HAMPTON BAY 48-LG Guía De Uso Y Mantenimiento

Assembly - Standard Ceiling Mount
1

Preparation for mounting

□
Remove the canopy ring (JJ) from the canopy (C) by
turning the ring counterclockwise until it unlocks.
□
Remove the mounting bracket (A) from the canopy (C)
by loosening the two canopy screws (HH) located in
the "L shaped slots".
□
Remove and save the two canopy screws (II) in the
round holes. This will enable you to remove the
mounting bracket (A).
HH
3
Assembling the fan
WARNING: Failure to properly install the locking pin could
result in the fan becoming loose and possibly falling.
□
Loosen, but do not remove, the setscrew (KK) on the collar
(MM) on top of the fan-motor housing (D).
□
Align the holes at the bottom of the downrod (B) with the
holes in the collar (MM) on top of the fan-motor housing (D).
□
Carefully insert the hanger pin (CC) through the holes in
the collar (MM) and downrod (B). Be careful not to jam the
hanger pin (CC) against the wiring inside the downrod (B).
□
Insert the locking pin (DD) through the hole near the end of
the hanger pin (CC) until it snaps into its locked position.
□
Re-tighten the setscrews on the collar (MM) on top of the
fan-motor housing (D).
2
Routing the wires
□
Route the wires exiting the top of the fan-motor
housing (D) into the decorative motor collar cover (F)
and through the canopy ring (JJ).
□
Make sure the slot openings are on top and route the
wires through the canopy (C) and then through the ball/
downrod assembly (B).
A
II
C
JJ
CC
7
MM
B
Please contact 1-855-HD-HAMPTON for further assistance.
C
JJ
F
B
D
C
JJ
F
DD
KK
D
HAMPTONBAY.COM